101
Context for the inexperienced: these are cone seat GM lugnuts, the cone portion is supposed to face IN towards the wheel as they are self centering, not OUT... guy didn't know wtf he was doin
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 10 Jun 2024
101 points (95.5% liked)
Cars - For Car Enthusiasts
3901 readers
70 users here now
About Community
c/Cars is the largest automotive enthusiast community on Lemmy and the fediverse. We're your central hub for vehicle-related discussion, industry news, reviews, projects, DIY guides, advice, stories, and more.
Rules
- Stay respectful to the community, hold civil discussions, even when others hold opinions that may differ from yours.
- This is not an NSFW community, and any such content will not be tolerated.
- Policy, not politics! Policy discussions revolve around the concept; political discussions revolve around the individual, party, association, etc. We only allow POLICY discussions and political discussions should go to c/politics.
- Must be related to cars, anything that does not have connection to cars will be considered spam/irrelevant and is subject to removal.
founded 1 year ago
MODERATORS
Making me glad I bought it off him before he killed someone.
This is also an older Cadillac that needs a very specific wheel bearing adjustment (yes, a bearing adjustment!) sequence every 30k miles and he didn't do it, so the front right tire had like 3/8" of play top to bottom. Sigh.
Or slightly more often, if you use wheels like this.
How the fuck do you adjust a bearing?
There's a nut that you tighten that changes how tight the bearing is being squeezed. You adjust it so that the bearing turns but doesn't have any play
More specifically, on modern cars, you'll normally have a sealed bearing/hub assembly, which does not need adjusting.
The ones that need adjusting are where you have an open spindle, the hub and [rotor|drum] are one piece, and the bearings are open and need to be greased. You'll have an inner bearing, then the hub/brake, then an outer bearing, topped off with a big nut. You snug that nut down until the spinning hub just starts to get tight, then back it off a 1/4 turn and fix it in place with a cotter pin.
More specifically modern tapered bearings are designed to run under continuous preload (the shaft inside with a nut provides constant clamping force so that the bearing is constantly in contact with its entire bearing race). These older bearings run with no preload, I think largely because machining tolerances were poorer and the races were not always perfect, so the weight of the car applies load to force bearing contact only where needed. The downside is that these bearings need repacking with grease and adjusting very frequently.
I guess I’ve only ever worked on pressed bearings, because I’ve never heard of that.
Yeah, your average passenger vehicle won't have them. Trailers and heavy duty trucks use them though. I only know about it through YouTube