Title. You know, for when you need to register somewhere, and you don't want to provide an actual email for account verification..

Long story short, my laptops DC input is no longer working. Yes, I've tested every aspect of the power supply. I even measured the motherboard input voltage, and it is being properly fed. I suspect a faulty DC-DC converter.

So, I had this idea of removing the battery permanently, and instead emulating it with a power supply with matching voltage. I don't really need the battery anyway (I mostly use a laptop for the form factor).

In theory, the laptop will then think it's running off of battery power. Permanently. Are there any consequences in terms of performance that could arise from this? Of course, the power settings will need to be adjusted, but beyond that I'm wondering if there's a hardware aspect that I cannot control.

Native English speakers... I hear the order of adjectives is important, and getting this wrong is jarring to read.

I'm making a pitch to upper management about building a "modular and versatile thingamawidget". Or is it "versatile and modular thingamawidget"?

If it doesn't matter, I think I'll go for the latter, as it abbreviates to something easily pronouncable without sounding like a paramilitary group or a ride sharing business.

I have a Dell Latitude 5420 laptop with LMDE, running kernel 6.1.0-12. This laptop has a builtin I219-LM ethernet controller that I can see via lspci. Some research indicates that this needs the e1000e kernel module, so I grabbed it from Intel, compiled it, and installed it. There were some complaints during the compilation, but nothing more than the average compilation process. Plus, it shows up in lsmod. Afterwards, lspci -vv displays it with the e1000e driver:

0000:00:1f.6 Ethernet controller: Intel Corporation Ethernet Connection (13) I219-LM (rev 20)
        Subsystem: Dell Ethernet Connection (13) I219-LM
        Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Interrupt: pin A routed to IRQ 16
        IOMMU group: 15
        Region 0: Memory at a6100000 (32-bit, non-prefetchable) [size=128K]
        Capabilities: [c8] Power Management version 3
                Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
                Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=1 PME-
        Capabilities: [d0] MSI: Enable- Count=1/1 Maskable- 64bit+
                Address: 0000000000000000  Data: 0000
        Kernel modules: e1000e

However, when I do lshw, it is listed as unclaimed:

  *-network:1 UNCLAIMED  
       description: Ethernet controller  
       product: Ethernet Connection (13) I219-LM  
       vendor: Intel Corporation  
       physical id: 1f.6  
       bus info: pci@0000:00:1f.6  
       version: 20  
       width: 32 bits  
       clock: 33MHz  
       capabilities: pm msi cap_list  
       configuration: latency=0  
       resources: memory:a6100000-a611ffff  

...and of course, it's still not showing in ifconfig. So, where do I go from here? Did I miss anything obvious?

And just for the record, I know that the ethernet port is working. It worked fine in Win11 before wiped the PC completely.

....to a reasonable degree, at least.

A couple of others I can think of:

• Crypto-boom of 2016ish: GPUs/mining rigs
• LLM/AI hype nowish: User generated data
• 90's dotcom bubble: Server space

Title, basically. My old torture device needs to be replaced, and while it's been mostly working OK, printers have no excuse for being as shitty as they are. So therefore I am looking for suggestions.

Specs:

• Must include a flatbed scanner
• prints in color
• Wifi connection preferred
• No PaaS or IaaS bullshit
• No driver weirdness. I'm going to use it on linux.
• Available "anywhere".
• Ability to sit powered and connected in my HarryPotteresque "server room" under the stairs for ages, unattended, and work without hazzle when I send it the bimonthly print job.

I know the geek community likes Brother. Any particular model?

For reference, this new printer will replace my aging Canon Pixma 4250.

Turns out Outlook sucks ass for anything not part of an office365 subscription, so I'm looking for something else. Preferably open source, preferably available via F-Droid.

One example I've seen is someone talking about being coconut-pilled.

...and I don't know which possibility is the least worrying

cross-posted from: https://feddit.nl/post/13434122

What are some interesting communities on Matrix worth checking out?

Title, pretty much. I'm in a couple of niche communities, and thought I should expa d into more generalized communities. All things tech are of interest, really.

Which communities are you in?