Issue Description: I have been having this issue with my raspberry pi running dietPi where it seems to lock up and I cannot SSH / access any of the services on it. The interesting part is that the interface seems to be up and I can still ping it on the local network but shows no video output. usually I get about 3-6 days before the issue appears again.

I am not really sure where to start to diagnose this issue. Any help would be appreciated!

Things Tried:

Reduced operating temp by getting a fan. I want to say this improved the length in between this issue appearing but don't really have any hard evidence.

uninstalled unused services

Limited active torrents in QbitTorrent

EDIT: Small thing to mention is that the CPU load is usually really high - like not uncommon for the load to be between 8-10 but I have seen it as high as 24.

Temporary fix:

Power cycle - everything comes up again in less than a minute.

Raspberry Pi 3B v2

OS: DietPi

Services:

Lidarr

Radarr

Sonarr

Prowlarr

Qbittorrent

Mullvad VPN - WireGaurd

SSH

I have spent the last couple of weeks getting my small used PC into my Proxmox server and it's going great! ...Until I quickly ran into the 256GB SSD size limit of the included drive. So I have ordered a much larger (2tb) one so I can expand much more.

Ideally, I would like to make an exact clone of what I have now just on my bigger SSD to avoid having to rebuild my VMs

One issue is that the computer has room for one drive only. I was hoping to get an exact clone to a USB drive then clone to the new drive once replaced with the new one.

Any suggestions or tips would be appreciated, thank you.

EDIT: Took another look in the guts of my system managed to get another 2tb SSD in there.

Disconnected cd drive and got a power splitter and boom. Could probably get another one even with another splitter as it's got a 3rd sata port.

Printed well and spray painted white to make them extra spooky. 👻

Edit: Should have linked to the design(not my design). Find it here.

I started resin printing and I am wondering if you guys use a full on resperator (if so is their a specific classification you'd recommend?) Or do you just use a cloth / surgical mask?

So far I have been using the mask that came with my printer (Elegoo mars 3 pro) but and not sure if that is sufficient.

Hello 3dpronting!

I am looking to get a resin printer as I have been reading they are better for smaller high detail prints. I am mainly looking to print miniatures for tabletop gaming.

I have been eyeing the Elegoo Mars 3 pro and the corresponding washing/curing station(Elegoo mercury plus 2 in 1).

Is this a good starting point? Am I biting off too much for a beginner?

Hello SelfHosted!

I have recently setup my own free tier oracle VPS and am looking to get my feet wet with some simple services that I can host on there to get started.

I should mention I have successfully setup SSH with the private key so that part is good to go.

Any ideas are welcome!