Pla can get brittle if exposed to a ton of moisture, so if it’s expected to flex, another option should be preferred- ASA, comes to mind.
But if there no real load on this box…. Pla or petg would be fine.
I a rack-hanger thing for my shaving stuff that has held up admirably for years.
I've had pla plant identification sticks outside for 3+ years in the sun, rain, and snow. One with a clear spray one without. Neither has deformed barely at all. Agreed, if it has no load it should be perfectly fine.
I'd be more concerned about heat on PLA than anything else. Black PLA, or inside a car... makes prints all droopy and sad.
PETG is almost the same material water bottles are made from. I've made a soap holder that gets, by definition, constantly wet in PETG and it's absolutely fine.
Both materials will last a long time indoors. Moisture will not cause issues with either material after printing.
PLA's dirty secret is that it will not breakdown under normal conditions. I have a PLA soap dish and its exactly the same as.it was the day i printed it.
I have printed ABS things that I use for scuba diving and freediving. It's like 4 years since I first printed them and they have been hours and hours in the sea.
ABS is great ... but then I bought some ASA. It's even greater since it's UV proof.
ABS is hard to print due to retractation. I have to use glue. I have less issue with ASA, it's easy to print, I don't know if it's due to the different brands.
ABS and ASA are making nasty fumes when printing. Be careful.
Finally, the last advice is to get one nozzle dedicated for ABS/ASA. The issue is that it needs to be printed at high temperature. Way higher than PLA. If you try to change the filament, the nozzle is either too cold to melt and purge ABS/ASA properly, or too hot and the PLA will be carbonized inside the nozzle. The nozzle will be clogged one way or the other. The solution is to dedicate one nozzle for PLA/PETG and one for ASA/ABS. It can be painfull to recalibrate the Z-offset on older printers.
@AVengefulAxolotl I have a few PLA things in the bathroom and I haven’t seen any issue with them or any indication of brittleness.
New Lemmy Post: Best options for prints handling high levels of humidity (https://lemmy.world/post/11318364)
Tagging: #3dprinting
(Replying in the OP of this thread (NOT THIS BOT!) will appear as a comment in the lemmy discussion.)
I am a FOSS bot. Check my README: https://github.com/db0/lemmy-tagginator/blob/main/README.md
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: !functionalprint@kbin.social or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible