37

Assuming it’s due to corrosion, am I correct that that whole section of exhaust should be replaced? I usually source my parts myself if I can. Any recommendations or things to avoid?

top 11 comments
sorted by: hot top controversial new old
[-] Brkdncr@lemmy.world 13 points 5 days ago

That section has been welded before. I’d have an exhaust shop cut, replace, and weld it again.

Is there a piece left between the cat and the exhaust pipe or did it break off flush?

[-] Reverendender@sh.itjust.works 3 points 5 days ago* (last edited 5 days ago)

~~Flush as far as I can tell~~

Yeah that’ll be a replace of at least the cat now unfortunately.

If there was a stub you can re-clamp to it and check for leaks. If there isn’t one you’re good to go until it falls off again.

[-] Reverendender@sh.itjust.works 7 points 5 days ago

I was completely wrong when I looked yesterday. I don’t think it s as bad.

\

[-] ShepherdPie@midwest.social 7 points 5 days ago* (last edited 5 days ago)

That's not a catalytic converter that's just a resonator (or possibly muffler) to set the exhaust tone. A cat is further up toward the engine and has O2 sensors before and after it. You can probably just clamp it for a while but the proper fix is to have a new resonator/muffler put in or have it cut out and replaced with a section of pipe.

[-] CaptDust@sh.itjust.works 5 points 5 days ago* (last edited 5 days ago)

You can probably weld or jerry rig this together with clamps in a pinch, but you should probably replace. Unfortunate it looks like Toyota designed it to be one pipe - sometimes these are separate pieces that are cheaper and easier to replace.

[-] ouRKaoS@lemmy.today 5 points 5 days ago

A piece of stainless steel or aluminum duct and a few hose clamps will hold this together long enough for you to forget that you rigged it when it breaks again and you actually have to replace something.

You might be able to get away with cutting out a section and clamping a new piece on.

If you do please check that there isn’t an exhaust leak.

[-] Mr_Blott@feddit.uk 3 points 5 days ago

That's well fixable. I got a stainless steel toilet brush holder and cut a cylinder out of it, cut it down lengthways and wrap it round, with some GunGum underneath. Four heavy duty jubilee clips to hold it in place.

Lasted for about 5 years on a MK5 Transit

[-] krolden@lemmy.ml 1 points 5 days ago* (last edited 5 days ago)

Yeah thats broke

Either clean up and attempt to weld a sleeve or get a new exhaust from the cat back

this post was submitted on 06 Oct 2024
37 points (97.4% liked)

Asklemmy

43556 readers
2337 users here now

A loosely moderated place to ask open-ended questions

Search asklemmy 🔍

If your post meets the following criteria, it's welcome here!

  1. Open-ended question
  2. Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
  3. Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
  4. Not ad nauseam inducing: please make sure it is a question that would be new to most members
  5. An actual topic of discussion

Looking for support?

Looking for a community?

~Icon~ ~by~ ~@Double_A@discuss.tchncs.de~

founded 5 years ago
MODERATORS