overview for WaltzingKea

Can You Inject Hot Glue Into 3D Printed Molds? | DIY Cable Repair & Protection - spoiler: yes, it's neat by WaltzingKea in c/3dprinting@lemmy.world

[-] WaltzingKea@lemmy.nz 4 points 2 months ago

Yeah I guess heat-shrink would do the job most of the time. But for when you have connectors that are too big to fit the right heat-shrink over or want to splice more than 2 wires together and want a waterproof seal over them this could be useful.

What does your current setup look like? by WaltzingKea in c/selfhosted@lemmy.world

[-] WaltzingKea@lemmy.nz 13 points 7 months ago

Bad. I have a Raspberry Pi 4 hanging from a HDMI cable going up to a projector, then have a 2TB SSD hanging from the Raspberry Pi. I host Nextcloud and Transmission on my RPi. Use Kodi for viewing media through my projector.

Bowden tube cap by WaltzingKea in c/functionalprint@kbin.social

[-] WaltzingKea@lemmy.nz 1 points 1 year ago

Yeah, didn't like the ones that would just slide down when you removed the cap.

7

Bowden tube cap (lemmy.nz)

submitted 1 year ago by WaltzingKea@lemmy.nz to c/functionalprint@kbin.social

5 comments fedilink

Simple bowden tube cap. https://www.printables.com/model/521608-bowden-tube-cap