Got my rg35xx-h and the provided screen protector had no glue, so I ordered one off Amazon, this is what came. I think I'll just stick to my 3d printed case.
EDIT: Edit just checked these didn’t have glue either, what’s going on haha Brand is Mr Sheild
Looks like it's running an amlogic chip. The only experience I have with linux and amlogic is the radxa zero. I've got a few with armbian and one with openelec. They are solid. I wonder if this gets a mainline kernel or not? I like the design.
I'll try and remember to dig about when I setup the SSH and let you know
Not by a long shot, it's on 4.9.170 about 2019 that's a bit worrying :D
Is it perhaps static cling, or do you have to apply with a water/soap solution?
Thought the same even though it's not in the instructions used a bit of isopropyl nothing
I usually just cut these down to the correct size I want with a ruler and a utility knife.
A community for the discussion of all single board computers. Raspberry Pi is ok, but there are so many other boards now that get looked over that deserve attention.
Post news, questions, your setups, guides, anything that has to do with SBCs. Server wide rules apply